Connecting Scu Pan-And-Tilt Unit Via Controller Cdcd2417 - Siemens SISTORE MX Installationshandbuch

8.4.10 Connecting SCU pan-and-tilt unit via controller CDCD2417

Siemens Building Technologies
Fire Safety & Security Products
1. Connect the pan-and-tilt units via controller CDC0501 or CDC0502 to the
RS485 port (COM2) of the SISTORE (see
2. Further information on this can be found in the product documentation for the
pan-and-tilt unit.
Connections
Signal SISTORE unit
9-pin Sub-D socket
A (Rx/Tx +) 2
B (Rx/Tx -) 3
CDCD2417 CDCD2417
Fig. 26 Controller CDCD2417 – system overview
For a more detailed description of the connections please refer to Section
MX / MX DVD or Section 7 D escription of SISTORE MX 3G / MX 3G DVD.
1 6 0 H 1 6 1 H
1. Connect the pan-and-tilt units via controller CDCD2417 to the RS485 port
(COM2) of the SISTORE (see
2. Further information on this can be found in the product documentation for the
pan-and-tilt unit.
Connections
Signal SISTORE unit
9-pin Sub-D socket
A (Rx/Tx +) 2
B (Rx/Tx -) 3
CDCD2417 interface configuration
Baud rate: 9600
Parity: Odd
Data bits: 8
STOP bit: 1
F ig. 25).
1 5 7 H
CDC0502 CDC0501
Rx/Tx + Rx/Tx -
Rx/Tx - Rx/Tx -
RS485
SISTORE MX / MX 3G
F ig. 26).
1 6 2 H
CDCD2417
Terminal 1 (Data +)
Terminal 2 (Data -)
Installation
PT40P
Data +
Data -
6 D escription of SISTORE
1 5 8 H 1 5 9 H
45
02.2009