Dell PowerEdge T30 Benutzerhandbuch Seite 91

4. Keep the Phillips #2 screwdriver ready.
Steps
1. Lower the system board into the chassis.
2. Push the system board towards the back of the chassis until the system board's screw holes align with the screw holes on the
chassis.
3. Secure the system board to the chassis using the eight screws.
NOTE: Dell recommends that you install screws from diagonally opposite corners.
Figure 51. Installing the system board
Next steps
1. Install the following:
a. heat sink and processor
b. memory modules
c. expansion cards
d. system fan
2. Connect all cables to the system board.
3. Follow the procedure listed in the After working inside your system section.
4. Enter the system service tag after you install the system board. For more information about entering the service tag, see the
Entering The Service Tag After Replacing The System Board section.
Related links
Vor der Arbeit an Komponenten im Inneren Ihres Systems
Installieren eines Kühlkörpers
Einsetzen eines Prozessors
Installieren eines Speichermoduls
Installieren einer Erweiterungskarte
Einbauen des Systemlüfters
Nach der Arbeit an Komponenten im Inneren Ihres Systems
91