Operation; Using Accessories; Transport; Storage - Kärcher CV 38/2 Originalbetriebsanleitung

Operation

Adjusting the height of the handle
The height of the handle is adjustable.
See page 4 for illustrations
1. Open the handle adjustment.
2. Move the handle up or down to set the
desired height.
3. Close the handle adjustment.
Switching on the device
1. Connect the mains plug.
2. Switch on the device at the main switch.
Electronic brush monitoring
The electronic brush monitoring continu-
ously monitors the function of the roller
brush.
The indicator light shows the respective op-
erating mode:
 Off: Roller brush functioning correctly.
 Lights up orange: Incorrect fibre height
setting - set the fibre height selection
knob to a lower fibre height.
 Also lights up orange at the lowest set-
ting: Replace the roller brush.
Note
Visual brush inspection: The degree of
wear can be determined by comparing the
differently coloured indicator tufts. Replace
the roller brush when the black bristles are
the same height as the red bristles.
Roller brush operation
ATTENTION
Risk of damage to the floor covering!
Do not operate the device continuously at
the same point.
1. Adjust the fibre height using the selec-
tion knob on the brush head.
2. Perform cleaning.

Using accessories

Vacuum with the crevice nozzle and cush-
ion nozzle.
See page 4 for illustrations
1. Pull the suction pipe out of the mount.
2. Remove the desired accessory from the
storage compartment and plug it onto
the suction pipe.
3. Perform cleaning.
14
Suction pipe operation
ATTENTION
Risk of damage!
When vacuuming using the suction hose,
allow the device to latch into position with-
out moving so that the brush motor switch-
es off and does not damage the carpet.
Switching off the device
1. Switch off the device at the main switch.
2. Pull out the mains plug.
The mains cable can be stored on the de-
vice.
See page 4 for illustrations
1. Wind the mains power cable onto the
winding aid.
2. Wind the mains cable around the cable
hook and handle.
3. To remove the cable, open the cable
hook and remove the cable from the
handle.
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during
transportation.
1. Wind the mains cable around the cable

storage.

2. Carry the device by the carrying handle.
3. When transporting the device in vehi-
cles, secure it to prevent it from slipping
or overturning in accordance with the re-
spective valid guidelines.
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during
storage.
The device may only be operated indoors.
English
Cable storage

Transport

Storage