Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1
x
2
3
x
4
5
6
7
To ensure your cat has unhindered access through the Pet Door,
measure the height from their tummy to the floor. Mark this height
on your wall, as this is where the bottom of the hole should be
positioned. Note: If there is a large drop on the outside of the
house you will need to place a step outside for your pet to access
the tunnel.
Attach a ball of Blu Tack (or similar adhesive putty) to each rear
corner of the external frame so that you can attach it to the wall and
use it as a template.
Stick the frame to the door using the mark you made for the height
of your pet's tummy to align the bottom edge of the hole. Use a spirit
level to ensure the product is level, then run a sharp pencil around
the inside edge of the frame and mark the centre of the drawn area.
Before you start to cut the hole, remove the Pet Door from the area
to minimise the amount of dust the it is subjected to.
Using the appropriate power tool and drill bit for your wall (please
consult a builder to identify the appropriate tools), drill a hole all
the way through the wall at the centre point you marked. We advise
you have somebody assisting you with a vacuum cleaner, so as not
to fill the room with dust.
Now, from the outside of your house, use the drilled hole as a
reference and mark up the outside wall where the tunnel will come
through. We advise that you mark this square a few millimetres
lower than the inside to allow for any rain collected in the tunnel
to run back outside.
Back on the inside of the house; whether you are cutting through
brick, wood, tiles or plaster, you should drill some pilot holes,
firstly around the perimeter of the line you have drawn and then in
the middle of the marked area. The holes around the perimeter
should go slightly over the line by no more than 2mm (1/16'') and
the holes in the centre should go all the way through the wall to
help with the cutting process.
Now remove all of the material in the centre using the most suitable
tools for the material you're cutting. We do not recommend that
you cut through to the outside in one go. Cut away material on the
inside of the house first and then move outside to cut the remainder
of the hole there. Do not make the hole much bigger than the
outlined area or you won't be able to screw the Pet Door to the wall.
EN
2
Werbung
