Assembling The Appliance; Storing And Transporting The Appliance; Cleaning And Maintenance - ROWENTA CITY SPACE CYCLONIC Bedienungsanleitung

• If you need to use an extension cord, make sure that it is in perfect condition and that it corresponds to
your mains voltage.
• Your vacuum cleaner is fitted with a safety device which prevents the motor from overheating. In certain
cases (when used on chairs, sofas, etc.) the safety device may be tripped and the appliance may make an
unusual noise that is not serious.
• Do not move the vacuum cleaner by pulling on the power cord, the appliance must only be moved using
its transport handle.
• Do not use the power cord to lift the appliance.
• Never unplug the appliance by pulling on the power cord.
• Never activate the vacuum cleaner without its dust tray (13) or without its HEPA filter case (14) (black
foam filter (14a) and HEPA filter (14b)).
• Use original Rowenta filters only.
• Use original Rowenta accessories only.
• If you have any difficulties in finding accessories or filters for this vacuum cleaner, contact the Rowenta
Customer Service.
• Switch off and unplug your vacuum cleaner each time after use.
• Always switch off and unplug your vacuum cleaner before maintenance or cleaning.
4. USE

ASSEMBLING THE APPLIANCE

• Firmly place the tube (19) in the vacuum opening (10) and turn to screw on – fig.1.
To withdraw the tube, turn in the opposite sense and pull – fig.2.
• If your vacuum cleaner is equipped with a telescopic tube* (20) : push the adjustment button forward, pull
out the tube as much as necessary and then release the button to block it – fig. 3. Otherwise, assemble both
tubes* (21) by turning them slightly – fig. 4.
• Attach the tube extension* (22) if necessary.
• Fit the corresponding accessory to the end of the tube or butt:
WARNING: Always switch off and unplug your vacuum cleaner before changing any accessories.
- For rugs and carpets: use the multi-surface nozzle (23) in the retracted brush position (fig. 5) or the Turbo-
brush* (fibers and animal hairs) (27* or 28*).
- For wood and hard floors: use the multi-surface nozzle (23) in the exterior brush position (fig. 6) or, for best
results, use the parquet nozzle* (24).
- For corners and hard to reach spots: use the crevice/brush nozzle (26) in the flat position.
- For upholstery and delicate surfaces: use the brush side of the crevice/brush nozzle (26) or the upholstery noz-
zle* (25).
PLUGING IN THE POWER CORD AND STARTING THE APPLIANCE
• Unwind the power cord completely, plug in your vacuum cleaner (fig. 7) and press the ON/OFF pedal.
On/Off (2) – fig. 8.
• Set the suction power using the manual power control located on the grip: increase the control opening
in order to manually diminish the vacuuming power, for example on fragile surfaces... – fig. 9.

STORING AND TRANSPORTING THE APPLIANCE

• After use, switch off your vacuum cleaner by pressing the ON/OFF pedal (2) –fig. 8- and unplug it (fig. 10).
• Rewind the power cord by pressing the power cord rewind pedal (3) - fig. 11.
• In the vertical position, place the nozzle (23) in its compartment under the appliance (1b) – fig. 12.
• In the horizontal position, place the nozzle (23) in its compartment at the back of the appliance (1b) – fig. 13.
• Transport your vacuum cleaner easily thanks to its transport handle (6).

5. CLEANING AND MAINTENANCE

Important: Always switch off and unplug your vacuum cleaner before maintenance or cleaning.
* According to model : this piece or accessory is specific to
certain models or can be bought separately.
10