Maintenance And Care; Servicing Guidelines - Echo PRO ATTACHMENT SERIES Bedienungsanleitung

Maintenance and care

Observe the following precautions when checking and maintaining your product after use:
 Turn power to unit off, remove battery, and make sure all moving parts have come to a complete stop.
An accident could occur if the product starts unexpectedly.
 Allow unit to cool before performing service.
You could burn yourself.
 Checking and maintenance requires specialist knowledge. If you are unable to check and maintain the product or deal with a
fault yourself, consult your dealer. Do not attempt to dismantle the product.

Servicing guidelines

Area
Nylon line cutting head
Cut off knife
Screws, bolts and nuts
Maintenance and care
If you have any questions or problems, please contact your dealer.
Loading nylon line
1. Wear Indicators
IMPORTANT
Maintenance
Inspect
Inspect/Clean
Inspect, Tighten/Replace
Maintenance and care
WARNING
Page
16
-
-
1. Cut one piece of line to recommended length.
 2.0 mm dia. - 6 m
2. Align arrows on top of knob with openings in eyelets.
3. Insert one end of nylon line into an eyelet, and push line
equal distance through nylon line cutting head.
4. Hold nylon line cutting head while turning knob clockwise to
wind line onto spool until about 13 cm of each line remains
exposed.
IMPORTANT
When the wear indicators located at the bottom of the nylon
line cutting head are worn smooth, replacement of the cover or
the entire nylon line cutting head is required.
16
Before use
•
•
•
Monthly