Closing The Door; Replacing The Lamp - Electrolux IK3318CR Benutzerinformation

12 www.electrolux.com
Problem
Water flows on the floor.
Temperature cannot be set. The FROSTMATIC or
DEMO appears on the dis-
play.
The temperature in the ap-
pliance is too low/too high.
If the advice does not lead to
the desired result, contact the
nearest Authorised Service
Centre.

7.2 Closing the door

1. Clean the door gaskets.
Possible cause
Food products prevent
that water flows into the
water collector.
The melting water outlet is
not connected to the
evaporative tray above the
compressor.
COOLMATIC function is
switched on.
The appliance is in dem-
onstration mode.
The temperature regulator
is not set correctly.
The door is not closed
correctly.
The food products' tem-
perature is too high.
Many food products are
stored at the same time.
The door has been
opened often.
The COOLMATIC function
is switched on.
There is no cold air circu-
lation in the appliance.
2. If necessary, adjust the door. Refer to
3. If necessary, replace the defective

7.3 Replacing the lamp

The appliance is equipped with a longlife
LED interior light.
Solution
Make sure that food products
do not touch the rear plate.
Attach the melting water out-
let to the evaporative tray.
Switch off FROSTMATIC or
COOLMATIC manually, or
wait until the function resets
automatically to set the tem-
perature. Refer to "FROST-
MATIC or COOLMATIC func-
tion".
Keep the Mode pressed for
approximately 10 seconds
until a long sound is heard
and display shuts off for a
short time.
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products tem-
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Open the door only if neces-
sary.
Refer to "COOLMATIC func-
tion".
Make sure that there is cold
air circulation in the appli-
ance.
"Installation".
door gaskets. Contact the Authorised
Service Centre.