AEG SCE81831FS Benutzerinformation Seite 33

Problem
Audible or visual alarm is on. The cabinet has been re-
A square symbol is shown in-
stead of numbers on the
Temperature Display.
The lamp does not work.
The lamp does not work.
The compressor operates
continually.
There is too much frost and
ice.
Possible cause
cently switched on or the
temperature is still too
high.
The temperature in the ap-
pliance is too high.
The door is left open.
The temperature in the ap-
pliance is too high.
Temperature sensor prob-
lem.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incor-
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed cor-
rectly.
The FROSTMATIC is
switched on.
The COOLMATIC is
switched on.
The door is not closed cor-
rectly or the gasket is de-
formed/dirty.
The water drainage plug is
not correctly positioned.
ENGLISH
Solution
Refer to "Door open alarm"or
"High temperature alarm".
Refer to "Door open alarm"or
"High temperature alarm".
Close the door.
Contact a qualified electrician
or contact the nearest Author-
ised Service Centre.
Contact the nearest Author-
ised Service Centre (the cool-
ing system will continue to
keep food products cold, but
temperature adjustment will
not be possible).
Close and open the door.
Contact the nearest Author-
ised Service Centre.
Refer to "Operation".
Wait some hours and then
check the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before stor-
ing.
Refer to "Closing the door".
Refer to "FROSTMATIC func-
tion".
Refer to "COOLMATIC func-
tion".
Refer to "Closing the door".
Position the water drainage
plug in the correct way.
33