BaByliss C2000E Anwendung Seite 9

INSTRUCTIONS FOR USE
Notes
• When using the unit for the first time, you might notice a little smoke and a
distinct odour: this is common and will disappear by the next use.
• Each time you use the appliance, you may see some steam. Do not be
concerned, this could be because of evaporation of the natural oils of the
hair, residual hair products (leave-in hair products, hairspray, etc.), or
excess moisture evaporating from your hair.
• A heat-protection spray can be used to provide optimal protection of the
hair.
Creating Waves
• Ensure the hair is clean, dry and free of dry shampoo, hairspray, mousse,
spray wax, styling dust and all other styling products.
• Comb through to remove any tangles and divide the hair into sections,
no bigger than 3cm wide.
• To turn the appliance on, slide the switch to the temperature setting
suitable for your hair type (See Temperature Settings). IMPORTANT!
Always allow the appliance to heat up fully before use. The LED light
will flash until the temperature setting has been reached.
• Select the wave setting by sliding the switch to wave mode (See Wave
or Smooth Settings).
• Wave direction can be selected by sliding the switch to desired
direction (See Wave Direction Settings).
• Always insert the hair into the appliance with the open part of the
ceramic chamber facing towards the head. For longer length hair,
insert the hair into the appliance further down the section to ensure
the hair is drawn into the ceramic chamber efficiently (Fig 1-2).
• Caution! If the appliance is used incorrectly, in certain instances a slight
tangle can occur. Should a tangle occur, firstly turn the appliance off
and refrain from pulling the appliance away from the hair. Gently tease
the hair out from the ceramic chamber until fully released.
• IMPORTANT! The neat section of hair must be inserted into the
opening, beyond the hair stopper (A) until it reaches the hair guide
(B). If too much hair is placed into the appliance opening and outside
of hair stopper (A) the appliance will beep continuously. To continue
using, remove the appliance from the hair and insert smaller sections
of hair. (Fig 3-4).
• IMPORTANT! Firmly close the handles together to allow the hair to be
drawn into the ceramic chamber.
• Keep the appliance in position and once the hair has been drawn into
the ceramic chamber, the appliance will beep 8 times. Continue to hold
the handles closed until the appliance sounds with the finish audio
indicator, this is to indicate the time is up.
9