Operation - Husqvarna S 13 Bedienungsanweisung

For models that do not have the front casters assembled
because of the limit of package:
• Assemble the front casters using the bolt or the nut
and the washer included in the package.
Make sure to dispose the package and the used product
components in correct procedure. Refer to local disposal
regulations. Make sure to recycle.
To attach the suction hose
There is a hose intake with a hose lock on the product.
The hose lock makes sure that the suction hose adapter
do not fall off.
Introduction
WARNING: Before you operate the product,
carefully read and understand the safety
chapter and the operation instructions.
Before use
WARNING: Before using the dust extractor
make sure that the power and voltage
corresponds with the voltage shown on the
machines rating plate, including extension
cords.
Grounding instructions
WARNING: The dust extractor must be
grounded. If it should malfunction or
breakdown, grounding provides a path of
least resistance for electric current to reduce
the risk of electric shock. The dust extractor
is equipped with a cord having an
equipment-grounding conductor and
grounding plug. The plug must be inserted
into an appropriate outlet that is properly
installed and grounded in accordance with
all local codes and ordinances.
896 - 001 - 15.11.2018
1. Lift the hose lock and attach the suction hose
adapter.
2. Lower the hose lock into the recess of the adapter.
To attach the nozzle on the hand
pipe
The floor nozzle has adjustable wheels. Adjust the
wheels to get the best suction effect. Adjust the wheels
with the knob, which is on the rear side of the nozzle.
The wheels and rubber strips of the nozzle can be
replaced. Keep the nozzle in good condition.

Operation

To start and stop
Use the switch to start the dust extractor.
Start switch
Black - 3 step
Red - 2 step
Automatic start function
When you use the dust extractor together with another
machine, there is an electrical outlet on the dust
extractor. Connect the machine to this outlet. Then when
you start it up the dust extractor will also start after
approximately 1-2 seconds. When you turn it off, the
dust extractor will continue to run for approximately 10
seconds to empty the hose and then stop.
Models with Models without
automatic start automatic start
0: Motor OFF
I: Motor ON
II: Automatic
start
0: Motor OFF
I: Motor ON
7