Husqvarna S 13 Bedienungsanweisung Seite 8

To assemble a new Longopac dust
bag
WARNING: Always clean the prefilter before
change of bag collection system.
Note: The dust extractor has Longopac system.
1. Put the dust bag in the holder.
2. Attach the dust bag holder to the container by
twisting it on to the holding pins.
3. Pull the bag up from the bag holder and put it around
the container.
8
4. Tighten a strap around the bag and the container to
secure the bag to the container.
5. Pull the dust bag over the bag holder.
6. Close the bottom of the dust bag with a cable tie.
To clean the filter
CAUTION: If suction remains poor, the pre-
filter needs to be replaced. If suction still
remains poor afterwards, the HEPA filters
need to be replaced. See instructions in
change the HEPA filter on page 10 .
The filter must be cleaned from time to time. This must
be done before changing the plastic bag collection
system and should also be done when work is
completed or when there is poor suction.
To
896 - 001 - 15.11.2018