babymoov Premium Care Benutzungsanleitung Seite 17

Receiver
1. Operation from battery pack
The Li polymer battery pack is already installed in the unit. To exchange battery pack, remove belt clip and slide
open the battery door in direction as shown, take out the battery pack and disconnect from socket.
2. Charging up the Lithium rechargeable battery
Connect the output plug of supplied 5V AC adapter to USB port 37 of the charger stand, make sure the polarity
is correct. The unit can either be in switch ON or OFF condition, place it into the charger stand. The charging
indicator 36 should light up white. Adjust the position of parent unit in case the indicator (36) does not light
up. During charging, the power on /battery low icon (27) should be flashing red. Once the battery is fully charged
up, the power on / battery low icon (27) should stay steady green. Either you can take it out or keep placing
it in the charger stand will cause no damage to battery. In the latter case, when the battery is being consumed
and voltage falls to a certain level, the charger stand will automatically start charging up the battery again.
Note : Before using the parent unit for the first time, charge up the Li polymer battery for at least three hours.
It is recommended to switch off the unit during first charging. Even without the Li battery pack being installed,
the unit can still oprate normally once place in changer stand, while the power on icon (27) will always stay steady
green.
CAUTION : BESURE THE BATTERY IN PARENT UNIT IS RECHARGEABLE TYPE BEFORE PLACING IN
CHARGER STAND. OTHERWISE EXPLSION MY RESULT .
37
BABYPHONE PREMIUM CARE • Instruction manual
17