Necchi 420 Gebrauchsanweisung Seite 47

8. Note;
The pattern " 76" of decorative pattern is Tack stitch. To prevent
ravelling, it may be better to memorize the tack stitch at the end of
decorative pattern. (Letter patterns are having built-in tack stitch.)
B. TO DELETE SELECTED PATTERN
1. If you selected undesired pattern, press
the clear (C) button short time (less than
0.5 sec.).
Machine will delete the last selected
pattern.
2. If you want to delete all patterns, press the clear (C) button long time (over 0.5 sec.).
Machine will delete all selected patterns.
C. TO CHECK SELECTED PATTERNS
You can check selected patterns as
following.
1. Press the read (R) button.
Last selected pattern will be highlighted.
2. Press the cursol (<) button.
Highlight will move one pattern to the left.
3. Check selected patterns by pressing
cursol (<) or (>) button.
4. Press the read (R) button again to return
to selecting mode.
D. ADJUSTING STITCH LENGTH AND
WIDTH
You can adjust the stitch width and length of
each decorative pattern.
1. Press the read (R) button.
2. Select the pattern (highlight) you want to
adjust by pressing the cursol buttons.
3. Press the tab button until the mode you
want to adjust will appear.
Mode a. Stitch Length can be adjusted.
Mode b. Stitch Width can be adjusted.
Adjust each setting by pressing the up
(+>>) or down (<<-) button.
The procedures to adjust them are same
as adjusting utility stitch, see page 13 to
adjust the lengh and width.
Note:
The letter patterns and some decorative
patterns can not change the length and
width. In this case, the mark c will appear.
4. Press the read (R) button again to return
to selecting mode.
45