Inhaltsverzeichnis
Werbung
STARTING TO SEW
The machine will be set to sew straight stitch
when power switch is turned on.
CAUTION: To prevent accidents.
While sewing, special care is required around
the needle.
As machine automatically feeds the fabric, do
not pull nor push fabric.
A. START AND END OF SEAM
1. Check the presser foot [Regular Foot (A)].
Refer to page 6 for changing the presser
foot.
2. Place the fabric under the presser foot and
lower the presser foot.
3. Hold back both threads and press the start/
stop button or press the foot controller
pedal.
Keep holding threads after sewing a few
stitches.
Lightly guide the fabric while sewing.
You can regulate the sewing speed by
sliding the speed control button.
Also, you can reduce the sewing speed by
pressing the slow button.
4. When you reach end of seam, press the
start/stop button to stop sewing or release
the foot controller pedal.
- TYPE A -
5. Press the thread cutter button.
6. Raise the presser foot lifter and remove the
fabric.
- TYPE B, C -
5. Raise the presser foot lifter.
6. Remove the fabric and cut threads with the
thread cutter, back to front.
- TYPE A ONLY -
CAUTION
1. Do not press the thread cutter button
when there is no fabric in the machine or
no need to cut the threads. The thread
may tangle, resulting in damage.
2. Do not use the thread cutter button when
cutting thread thicker than #30, nylon
thread or other speciality threads. In this
case, use the thread cutter located on the
left side of the machine. (See page 9)
24
TYPE A 1
TYPE B 1
TYPE C 01
- TYPE A -
- TYPE B, C -
NOTE
After you cut the
threads by using the
thread cutter button,
hold upper thread
only at the next
starting of seam. (No
need to draw up the
bobbin thread)
Werbung
Inhaltsverzeichnis
