Singer SHG 6203 Handbuch Seite 8

The scale that develops inside the boiler will not deposit onto the walls. Just calc-clean
the boiler once or twice a month to keep your indelicate in good condition.
1. Make sure that the steam tank has been unplugged for more than 2 hours and is not
hot.
2. Remove the detachable water tank.
3. Hold the steam tank with both hands and shake well.
4. Turn the steam station on its side and remove the Calc-Clean rinsing cap & rinsing
plug with a coin.
5. Empty the steam tank by pouring out the water into the cup or into the sink.
6. Fill the boiler with fresh water by means of the cup and shake again.
7. Empty the boiler by pouring out the water into the cup or into the sink.
Repeat steps 6 & 7 twice to obtain the best result.
8. Put the Calc-Clean rinsing plug back into the steam tank and tighten it with a coin.
9. Put the Calc-Clean rinsing cap back onto the boiler.
10. Products for use in a better state, we recommend the use of time one week after you
open the cleaning bolt into the water, the first cleaning of the boiler to the boiler, so
that the sediment within the boiler to be promptly removed.
11. Pump set within the product, do not water mixed with perfume and fats and oils to
the water tank built.
Storage
Always let the iron cool down before storing it.
1. Switch the mains supply socket off and remove the plug. Allow your steam generator
to completely cool down.
2. Empty any remaining water from the water tank. Then, open the cleaning bolt, empty
the water inside the boiler. Finally, cleaning bolt installed reset
3. The power cord wound into a single unit, as shown.
4. Power cord bundled with a power cord tie, and hang in the power cord hook, as
shown.
6
03_Instruction Manual.indd 6 14.05.2012 19:00