Bosch BPT-S 4.6 Betriebsanleitung Seite 187

English
CAUTION
NOTICE
Bosch Power Tec GmbH
5.9: Cable screw connection
Risk of injury due to damaged wire strands and
incorrect screw connections (AC)
Damaged wire strands may break. Cables that are not
properly screwed into place can be pulled out or
damaged.
This may result in electric shock or heat build-up.
Do not damage the wire strands

Carry out the screw connection according to

instructions
 Observe the tightening torques
Material damage due to failure to observe the
specified tightening torques
Insufficient tightening torque can cause the cable to
be pulled out of the plug. Excessive tightening torque
can break the cable at the contact or the plug. In both
cases (too low, too high), this can result in a short
circuit, fire or device failure.
Tighten the cable to the specified tightening torque.

Tighten the screw connection to the specified

tightening torque.
■
Plug is terminated.
Bosch BPT-S 3 / 3.68 / 4 / 4.6 | Operating manual
Installation | 69