11.3 Alarm output
The sensor will compensate for soiled optics to a certain limit. If this limit is reached, the alarm output
will be activated (grey wire, pin 5).
11.4 Switching input (Enable)
The switching input (red wire, pin 8), can gate the switching output
Sensor with one switching output
Switching input connected to GND
or not connected:
Switching input connected to +Vs:
Sensor with two switching outputs
Switching input connected to GND
or not connected:
Switching input connected to +Vs:
The switching output is active
The switching output is OFF
The switching outputs are active
The switching outputs are memorised
Seite / Page 70