Zanussi ZRB34214XA Benutzerinformation Seite 52

have a 30mm separation between the sides of
the appliance and any surrounding furniture.
Levelling
When placing the ap-
pliance ensure that it
stands level. This can
be achieved by two
adjustable feet at the
bottom in front.
Electrical connection
Before plugging in, ensure that the voltage and
frequency shown on the rating plate correspond
to your domestic power supply.
The appliance must be earthed. The power sup-
ply cable plug is provided with a contact for this
purpose. If the domestic power supply socket is
not earthed, connect the appliance to a sepa-
rate earth in compliance with current regula-
tions, consulting a qualified electrician.
The manufacturer declines all responsibility if
the above safety precautions are not observed.
This appliance complies with the E.E.C. Direc-
tives.
Door reversibility
Important! To carry out the following
operations, we suggest that this be made with
another person that will keep a firm hold on the
doors of the appliance during the operations.
To change the opening direction of the door, do
these steps:
• Open the door and empty the shelves
• Unscrew the screws of the upper hinge. (1)
• Remove the door from the middle hinge pivot.
(2)
• Place the cover of the upper hinge into the
holes on the opposite side.
• Screw off the screws of the middle hinge (3)
52
1
2
• Remove the plugs on the upper side of both
doors and move them to the other side.
• Remove the lower door from the lower hinge
pivot. (4)
4
• Screw off the pivot of the lower hinge (5) and
screw the lower hinge pivot (6) into the left
drill of the lower hinge.
6
5
• Screw off the screws of the lower hinge and
remove the hinge. (8)
• Screw off the lower cover plugs and screw
them into the hole on the opposite side. (7)
• Put the lower hinge on the opposite side and
fix it with the screws. (8)
www.zanussi.com