Bosch 27 LC GGS Professional Originalbetriebsanleitung Seite 21

OBJ_BUCH-247-002.book Page 21 Thursday, February 26, 2009 9:48 AM
Noise/Vibration Information
Measured values determined according to EN 60745.
Typically the A-weighted noise levels of the product are:
Sound pressure level
Sound power level
Uncertainty K=
Wear hearing protection!
Overall vibrational values (vector sum of three directions) determined
according to EN 60745:
Grinding surfaces (roughing):
Vibrational emission value a
Uncertainty K=
The vibration emission level given in this infor-
mation sheet has been measured in accordance
with a standardised test given in EN 60745 and
may be used to compare one tool with another.
It may be used for a preliminary assessment of
exposure.
The declared vibration emission level repre-
sents the main applications of the tool. However
if the tool is used for different applications, with
different accessories or poorly maintained, the
vibration emission may differ. This may signifi-
cantly increase the exposure level over the total
working period.
An estimation of the level of exposure to vibra-
tion should also take into account the times
when the tool is switched off or when it is run-
ning but not actually doing the job. This may sig-
nificantly reduce the exposure level over the to-
tal working period.
Identify additional safety measures to protect
the operator from the effects of vibration such
as: maintain the tool and the accessories, keep
the hands warm, organisation of work patterns.
Declaration of Conformity
We declare under our sole responsibility that
the product described under "Technical Data" is
in conformity with the following standards or
standardization documents: EN 60745 accord-
ing to the provisions of the directives
2004/108/EC, 98/37/EC (until 28 Dec 2009),
2006/42/EC (from 29 Dec 2009).
Bosch Power Tools
h
Technical file at:
Robert Bosch GmbH, Postfach 10 01 56,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider
Senior Vice President
Engineering
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
07.10.2008
Assembly
Before any work on the machine itself, pull
the mains plug.
Mounting the Grinding Tools
(see figure A)
– Clean the grinder spindle 3 and all parts to
be mounted.
– Hold the grinder spindle 3 on the spanner
surfaces with the open-end spanner 7 (size
17 mm).
– Loosen the clamping nut 2 with the open-end
spanner 7 (size 17 mm) by turning in anti-
clockwise direction.
– Insert the clamping shaft of the grinding tool
to the stop into the collet chuck 1.
– Tighten the clamping nut 2 with the open-
end spanner 7 (size 17 mm) by turning in
clockwise direction.
English | 21
0 601 ... 212 ... 215 ...
dB(A) 81 83
dB(A) 92 94
dB 3 3
2
m/s 3.0 6.0
2
m/s 1.5 1.5
Dr. Eckerhard Strötgen
Head of Product
Certification
1 609 929 K42 | (26.2.09)