Lightmaxx Slim Spot ARC Bedienungsanleitung Seite 14

Safety Instructions! Please read before connection
and operation!
RISK OF ELECTRIC SHOCK.
DO NOT OPEN!
WARNING: To prevent the risk of electrocution, do not
open the device.
Please leave all maintenance and repairs to a qualifi ed
service workshop or contact your distributor.
The lightning fl ash symbol warns the user
about non-insulated current and the risk of
electrocution.
The exclamation mark symbol warns the user
about important maintenance and operating
inst-ructions in the manual.
Read the manual.
This symbol indicates the minimum distance
to illuminated objects.
• Please recycle the packaging correctly to protect the
environment.
• Occasionally a new product may cause undesirable
odours or even emit smoke for a short period of time.
This reaction is normal and will
disappear after a few minutes.
• The device is intended exclusively for us indoors
(IP20)! Please use this device only in dry environments.
Keep the device away from rain,
moisture, direct heat and dust.
• To prevent condensation from forming in the device,
please allow the device to adapt to the surrounding
temperature before operating.
• Please position the device in a well ventilated area,
beyond the reach of fl ammable materials or liquids.
• Do not block any ventilation openings, as it may cause
over-heating.
• Please remove the power cable if the device is not
operated for extended periods of time or maintenance
is to be conducted.
• This device is designed to operate in environments
with a maximum temperature of 40° Celsius.
• The installation of the device is not to be conducted
by inexperienced persons and must adhere to the
mechani-cal and electrical safety
standards of the local law.
• In case of a damaged power cable, it must be
replaced by an original replacement part from the
14
manufacturer.
• Ensure that the supply voltage does not exceed the
voltage
• capacity indicated on the housing of the device.
• In case of failure of the device, please contact the dis-
tri-butor and stop all operations of the device immediately.
• The device must keep a minimum distance of one metre
from fl ammable materials or liquids.
WARNING: Do not look directly into the light source!
Do not operate this device in the presence of persons
suffering from epilepsy!
OVERHEAD INSTALLATION
The installation must be performed exclusively by qua-
lifi ed personnel. Incorrect installation can cause serious
injuries or da-mage. Note the load limits of the selected
installation position.
Ensure that during installation or dismantling/ maintenan-
ce there are no unauthorized persons below the device.
Manufacturer: MUSIC STORE professional GmbH,
Istanbulstraße 22-26, 51103 Köln, Germany