Troubleshooting - Motorola GMLN5075 Installationsanleitung

68012009097.book Page 12 Tuesday, May 21, 2013 11:44 AM

TROUBLESHOOTING

This paragraph provides typical malfunctions that can occur
during the first operation of the GMLN5075 and GMLN5371
Vehicular Charger Kits. The paragraph also suggests
corrective actions.
Prior to troubleshooting the malfunction, verify the following:
• Your TETRA Handportable Terminal functions properly
outside the cradle.
• The cable to the cradle is properly connected.
Identify the malfunction in accordance to Table 3 on page 12.
Follow Table 3 steps after inserting the TETRA Handportable
Terminal into the cradle and turning the ignition switch to ON.
Table 3: Troubleshooting Procedures
No. Malfunction
1 Display
message
"Charger/
Holder
Connected"
does not exist.
2 Charging
Indication does
not exist.
MOTOROLA, MOTO, MOTOROLA SOLUTIONS and the
Stylized M logo are trademarks or registered trademarks of
Motorola Trademark Holdings, LLC and are used under
license. All other trademarks are the property of their
respective owners.
© 2013 Motorola Solutions, Inc. All rights reserved.
Corrective Action
1. Remove the TETRA Handportable
Terminal from the cradle and install it
again.
2. Check the cradle accessory connector.
Ensure the cradle is connected
properly.
1. Verify that the ignition switch is in the
ON position.
2. Check the power cable. Verify that the
red wire is connected to the positive (+)
terminal on the vehicle's battery, the
black wire is connected to the vehicle's
chassis and the blue wire is connected
to the ignition line.
3. Check the fuses installed on the red
and blue wires. Verify their
serviceability and replace if required.
12