Replacement Parts/Accessories - Ossur OFM2 Gebrauchsanweisung

• The prostheses must be manufactured in compliance with the generally acknowledged professional rules of the
orthopaedic appliances trade.
• If the patient's suitability for wearing the prosthesis changes (e.g. body weight, mobility, etc.), the prosthesis
must be checked without delay.
• If the prosthesis has been exposed to unusually high stress, e.g. a fall, it must be inspected in a prosthetic
workshop immediately for possible damage.
• Safety-relevant regulations for individual fittings (see relevant Instructions for Use) must be observed
COMBINATION OF DIFFERENT MODULAR COMPONENTS:
The above general conditions apply and additionally:
• Only use modular components that comply with the requirements of ISO 10328
• Only use modular components that comply with the requirements of the Medical Devices Act
• The modular components must be suitable for each other and fit the standard pyramid or 30 mm system.
Combination of different fittings
• The above general conditions apply in addition to:
• Only use fittings that comply with the requirements of ISO 10328
• Only use fittings that comply with the requirements of the Medical Devices Act
• The fittings must be suitable for each other and fit the standard pyramid or 30 mm system.
USEFUL LIFE
Maximum useful life of the Balance Knee OFM2 knee joint* is 36 months
REPLACEMENT PARTS, ACCESSORIES
No. Description
1 Adjusting screw for extension spring
2 Extension assist spring
5 Screw for tube receiver
21 Extension buffer
23 Retaining screw for release lever
27 Release screw
- Release lanyard
33 Dual function lever
Only the listed replacement parts and accessories are available. To have a joint inspected please send the joint for
repair to Össur. We will provide you with a service joint for the duration of the repair.
Article No.
1.970.864
1.970.865
1.970.866
1.970.870
1.970.867
1.970.868
1.970.869
M.721.223
9