Analog Output - Lowara SM30 BSETF3 Programmierhandbuch

en
3 AI1 FILTER
4 AI1 UNIT
5 AI2 SENSOR TYPE
6 ZERO ADJUST AI2
7 AI2 FILTER
8 AI2 UNIT
9

ANALOG OUTPUT

10 AN.OUT1 TYPE
6.2.11 PROGRAMMING DIGITAL INPUTS / OUTPUTS
Phase Display
0 DIGITAL IN / OUT
1 PR.SW.1 LOGIC
2 PR.SW.2 LOG
3 PR.SW.3 LOGIC
4 CONFIG. AUX1 IN.
5 CONFIG. AUX2 IN.
48
Software filter (no. samples) of the
analog input AI1 signal
Setting the unit of measurement on
input AI1
Type of transducer connected to the
analog input AI2 (if selected on System)
Visible only if 4-20mA selected.
Acquisition of input zero 4 4-20 mA
Adjustment is possible only in the range
3.5... 4.5mA
If adjustment has a positive result the
message SENSOR ADJUST OK appears
If out of range the message SENSOR
ADJUST KO appears
Software filter (no. samples) of the
analog input AI2 signal
Setting the unit of measurement on
input AI2
Function that can be attributed to analog
output Out_A
Full scale analog output AO1
Comment
Terminal 2 only if pressure switch
operation enabled.
Terminal 3 only if pressure switch
operation enabled.
Terminal 4 only if pressure switch
operation enabled.
Configuration of input AUX1 as max.
pressure pressure-switch or external
auto-test command.
Configuration of input AUX2 as external
consent (NO) or external alarm (NC).
1..199 1
DISABLED bar
bar
°C
m³/h
m
4-20 mA 4-20 mA
0-20 mA
0-10 V
0-2 V
YES NO
NO
1..199 1
DISABLED bar
bar
°C
m³/h
m
DISABLED DISABLED
AI1
AI2
4-20 mA 4-20 mA
0-20 mA
0-10 V
0-2 V
Field Default
NC / NO NC
NC / NO NC
NC / NO NC
DISABLED DISABLED
HIGH
PRESSURE
START
AUTOTEST
DISABLED DISABLED
EXT.ALARM
EXT.ON/OFF