General Information; Product Description; Operation - Lowara SM30 BSETF3 Programmierhandbuch

en

1 GENERAL INFORMATION

GSD and GSY booster sets are designed to transfer and increase the pressure of clean water in plumbing
systems in homes, offices, communities and industry.
This manual describes the programming of the electronic control board, referred to below as SM30
BSETF3. For the instructions for use and maintenance of the booster set, see the respective manual.
Characteristics and Limits of use
Rated using voltage of the SM30 BSETF3 board: 24 Vac/Vdc +/- 15%
Absorption:
Using and storage environment temperature:
Relative humidity:
Environment:
IP protection rating of front panel:
Dusty environments with the presence of sand, or damp environments such as at the seaside, may cause
premature deterioration, compromising regular operation.
CHECKING THE MATERIAL
On delivery of the booster set, check that the material received corresponds to what is indicated on the
transport documents that accompany it.
CAUTION

2 PRODUCT DESCRIPTION

Electronic control board with LCD display, warning light and control buttons, fitted in the booster set
electric panel.

3 OPERATION

1
2
3
32
KEEP ALL THE DOCUMENTATION SUPPLIED WITH CARE.
PAPER DOCUMENTATION MUST NOT BE KEPT IN A DAMP PLACE!
4
4 VA max (approx. 0.5 VA in stand-by)
-10 °C + 65 °C
30% at 90 °C MAX, without condensation
Internal
IP65
The stored programme (Software) operates the pumps
by means of the electric panel according to the system
demand.
The LCD display gives indications on the system
operating status, along with the warning leds:
1) LINE: Green led, supply voltage present;
2) FAULT: Red led, indicating a fault;
3) LOW LEVEL: Red led, presence of low pressure/level
alarm on intake;
4) P : Green led; pump operating;
1
....
P operating.
3
The number of pumps depends on those present in the
set.