B) In The Web Interface; Maintenance And Cleaning - Conrad N150 Bedienungsanleitung

b) In the Web Interface

• Connect the PoE adapter to the plug-in mains adapter and plug it into a mains socket to reset
the WLAN router to the factory settings with the web interface. Connect the PoE adapter to
the router and wait for approx. 1 minute until the starting process is completed.
• Log into the web interface as described in chapter 8.
• First click "Administration" and then "Settings Management".
Click the button "Load Default" to start the reset process.
• Whether or not the reset was accepted can be seen by all LEDs except for the Power LED at
the router going out for a certain time after a few seconds.
• The device now restarts. This will table take about 1 minutes. Then it is reset to factory set-
tings.

15. Maintenance and Cleaning

Servicing or repair must only be carried out by a specialist or specialist workshop. The product
contains no parts that require servicing by you. Therefore, do not open it.
A dry, soft and clean cloth is suffi cient for cleaning the outside.
Never use any aggressive cleaning agents, alcohol or other chemical solutions that
would damage the casing (discolouration).
72