Conrad N150 Bedienungsanleitung Seite 56

• The device now restarts and confi guration is assumed.
Please note:
You need to log on to the web interface again after the restart if oyu changed the
IP address. For this, enter the changed IP address into the address line of the
browser. It may also be necessary to disconnect your PC from the network briefl y
fi rst to have a new IP address assigned to it. You may also restart your PC.
Also observe chapter 12 a) on how to change the IP address.
• If desired, you may also change other settings now. Also observe chapter 12 of these operat-
ing instructions on this.
• Remove the network cable that is currently connected to your computer to take the device into
operation as an access point. Connect this cable to a free USB port of your router. Then also
remove the cable that connects the AP to the PoE adapter for a few seconds. This restarts the
AP.
• Confi guration is now complete. Now you can install the device in the place desired by you as
described in chapter 13.
Please note:
Proceed as follows if you have not put the IP-address in the DHCP-area of your
router and later want to change the confi guration.
Disconnect the connection cable from your router. Then restart the access point
or disconnect it from the power supply briefl y. Also restart your PC. Then you can
access the web interface as in the basic confi guration.
56