Ramsey Winch HD-P 177,9 Bedienungsanleitung Seite 12

If splines inside drum driver #102 are damaged, drum driver must be replaced. Remove drum driver by unscrewing (8)
9.
capscrews #105. If bushings show signs of wear, replace by pressing old bushings from drum #101 and removing o-
rings from grooves in drum and drum driver. Place well oiled o-rings #106 into driver and drum. Place well oiled o-ring
#107 on outside of driver. Press bushings #104 into drum driver until flange is flush and #103 is flush against drum
103
Remove brake assembly screws #17 from brake #36a attaching brake to end bearing #6. Remove coupling #4 and
10.
gasket #36e from end bearing. Take note of mounting configuration for proper mounting of parts during re-assembly.
106
17
30c
30b
101
107
105
30e
9
102
106
104
6
.