BabyGo Iso 360 Bedienungsanleitung Seite 18

Car Seat + Isofix
4.2 Usage
of buckle
1 2 3
Step1: Insert the left and the right pieces of buckle together.
Step2: Insert the two pieces into the slot of the buckle at the same time. hearing
„click" means the buckle gets stuck, pull the pieces of the buckle and check whether
the buckle is locked correctly.
Step 3: If you want to release the safety belts, it need to press the red button, then
the pieces pops up.
4.3 Adjust the
length of harness
1 2
Picture1: Tighten the harness.
Pull the harness upwards to remove the slack from the lap sections of the harness
then pull the front stretch belt until the harness is fully tightened. The harness
should be adjusted as tightly as possible without causing discomfort to your child.
A loose harness can be dangerous. Check the harness adjuster and tighten each
time when the child is placed in the seat.
Picture 2:Loosen the harness.
The harness can be slackened by pressing the adjuster (under the seat cover) on
the front of the seat. Press down the adjuster as you grip the two harness with your
another hand. Pull the harness towards you to loosen the harness.
4.4 Adjust and check the height of headrest and shoulder strap
4.4.2 Check the height of headrest and shoulder strap
Right
Wrong
Always check whether the harness are at the correct height for your child. If not,
repeat adjusting the height of headrest (see 4.4.1).
18