Electrical Safety - Bosch UniversalRotak 450 Originalbetriebsanleitung

Remove the plug from the socket:
– Whenever you leave the machine.
– Before clearing a blockage.
– Before checking, cleaning or work-
ing on the machine.
– After striking a foreign object. In-
spect the machine for damage and
change the blade as necessary.
– If the machine starts to vibrate ab-
normally (check immediately).
Connecting to the mains
The voltage of the power source
u
must correspond with the data on
the type plate of the product.
We recommend that this product is
u
only connected into a socket which
is protected by a circuit-breaker that
would be actuated by a 30 mA resid-
ual current.
Only use or replace power supply
u
cables for this unit which correspond
to the types indicated by the manu-
facturer. See the operating instruc-
tions for the order no. and types.
Never touch the mains plug with wet
u
hands.
Do not run over, crush or pull the
u
power supply cord or extension
cord, otherwise it may be damaged.
Protect the cable from heat, oil and
sharp edges.
The extension lead must have a cross
u
section in accordance with the oper-
ating instructions and be protected
against splashed water. The connec-
tion must not be in water.
Bosch Power Tools
Always wear gardening gloves
u
when handling or working near the
sharp blades.

Electrical Safety

Warning! Switch the
product off and pull the
mains plug before any main-
tenance or cleaning. The same ap-
plies when the mains cable is dam-
aged, cut or entangled.
The blade continues to rotate for a
u
few seconds after the machine is
switched off.
Caution do not touch the rotating
u
blade.
Your product is double insulated for
safety and requires no earth connec-
tion. The operating voltage is 230 V
AC, 50 Hz (for non-EU countries
220 V, 240 V as applicable). Contact
your Bosch Service Centre for details.
If in doubt contact a qualified electri-
cian or the nearest Bosch Service
Centre.
For increased electrical safety use a
Residual Current Device (RCD) with a
tripping current of not more than
30 mA. Always check your RCD every
time you use it.
Keep the supply cables away from
moving hazardous parts and avoid
damage to the cables; this can lead to
contact with live parts.
The connections (plugs and sockets)
should be kept dry and off the ground.
English | 13
F 016 L81 863 | (22.11.2018)