Functional Description; Operation - Makita 3706 Bedienungsanleitung

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function on
the tool.
Adjusting depth of cut
Fig.1
To adjust the shoe, turn the thumb screw to loosen. Slide
the shoe to the desired position and tighten the thumb
screw securely. Check for the proper clearance beneath
the workpiece before cutting so that the bit will not strike
a hard surface such as the floor, workbench, etc.
Switch action
OFF
1
001625
CAUTION:
Before plugging in the tool, always check to see
•
that the switch lever actuates properly and returns
to the ''OFF'' position.
To start the tool, move the switch lever to the ''ON''
position.
To stop the tool, move the switch lever to the ''OFF''
position.
This can be done in the forward area of the switch lever
or by bumping off the rear area of the switch lever.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the tool.
Installing or removing bit
Fig.2
CAUTION:
Do not tighten the collet nut without inserting a bit,
•
or the collet cone will break.
When using the bit with 6.35 mm shank diameter,
•
first remove the adapter from the collet cone, then
install the bit.
To install the bit, insert the bit all the way into the collet
cone.
Press the shaft lock to keep the shaft stationary and use
the wrench to tighten the collet nut securely.
To remove the bit, follow the installation procedure in
reverse.
1. Switch lever
2. Bump off switch
ON
2
Changing the collet cone
Fig.3
CAUTION:
Use the correct size collet cone and adapter for the
•
bit which you intended to use.
Do not tighten the collet nut without inserting a bit,
•
or the collet cone will break.
To change the collet cone, loosen the collet nut and
remove. Remove installed collet cone and adapter and
replace with desired collet cone and adapter. Reinstall
collet nut.

OPERATION

Fig.4
CAUTION:
Avoid forcing the bit to bend or twist. It may snap.
•
Before turning the tool on, make sure the bit and
•
collet nut are securely tightened.
Hold the tool secure with the bit pointing in a safe
direction not contacting any surface and slide the switch
to the ''ON'' position. Wait until the tool attains full speed.
When starting the multipurpose bit into the material, hold
the tool at approximately a 45 degree angle with the edge
of the shoe base contacting the material.
Carefully bring the tool to a straight position so the shoe
base is in full contact with the material.
Fig.5
When inserting the drywall guide bit into the drywall,
carefully insert the bit straight until the shoe base is in full
contact with the material.
Fig.6
Move the tool slowly with a constant pressure in a
clockwise direction to make the cut.
When cutting straight line, clamp a straight board firmly
to the material and use it as a guide. Move the tool in the
direction of the arrow with the shoe base flush with the
side of the guide board.
Fig.7
When the cut is complete, turn the tool off and wait for the
bit to stop rotating and then carefully remove it from the
material.
NOTE:
1. When using this tool, the rotating action causes
the tool to pull. The less pressure applied to the
tool causes less pull and provides a more accurate
cut. Excessive pressure or fast cutting can cause
the bit to dull or break premature.
2. When cutting drywall around outlet boxes, cut in a
counterclockwise direction for ease of cut.
3. The standard bit included with this tool is for
cutting drywall only. When cutting materials other
than drywall, do not use the standard drywall guide
bit.
6