Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2.6 Report/Print count results
Press [REP] to view the counting results on the display.
Press and hold [REP] for 3 seconds, the counting report will be printed by the thermal printer (Safescan TP-220) or
send to the Safescan Money Counting Software.
2.7 Feeding hopper adjustment
The position of the hopper adjusting screw has already been set in optimal position in the factory. When unnecessary
counting errors occur (i.e. Double notes/chain notes), it could be necessary to adjust the hopper-adjusting-screw to
optimize the banknote transport, when:
•
The notes can not be counted smoothly, increase the note thickness distance.
•
The machine stops and display the codes "double notes" or "chain notes", decrease the note thickness
distance.
Turn the screw clockwise (+) to increase the note thickness distance, turn the screw counter-clockwise (-) to
decrease the distance.
Note:
the adjustment screw is very sensitive, make only minor adjustments (see picture).
2.8 Using the hopper guides
1.
The width of hopper guides can be adjusted manually. Both hopper guides move simultaneously.
2.
In order to have the best counting result, the width of the hopper guide should be the same as the largest
note counted.
3.
In order to optimize counterfeit detection functions, the width of the hopper guide should be the same as
the largest note counted.
6
(available for the 2665 & 2685 model)
1.
2.
3.
Denomination
Sheet number
Value
Werbung
Inhaltsverzeichnis
