Electrolux WASL 3 T Benutzerinformation Seite 45

2a
3
To install your washing machine at the
same level as surrounding furniture, pro-
ceed as shown on picture 4.
Water supply
Install the supplied water inlet hose at the
rear of your washing machine by proceed-
ing as follows. Do not reuse an old hose.
The water inlet hose can not be extended. If
it is too short, please contact the after-sales
service.
1
Open the water inlet tap. Check there are
no leaks.
Drainage
Fit the U-piece on
the drainage hose.
Place everything in a
drainage point (or in
a sink) at a height of
between 70 and 100
cm. Ensure it is posi-
tioned securely. Air
must be able to en-
ter the end of the
hose, to avoid any risk of siphoning.
2b
4
2
The drain hose must never be stretched. If
it is too short, contact an engineer.
Electrical connection
This washing machine must only be con-
nected in single-phased 230 V. Check the
fuse size: 13 A for 230 V. The appliance
must not be connected with an extension
lead or multi-plug adaptor. Ensure that the
plug is earthed and that it is in accordance
with current regulations.
Positioning
Position the appliance on a flat and hard
surface in a ventilated location. Ensure the
appliance does not come into contact with
the wall or other furniture.
To move your appliance, proceed as fol-
lows:
Place it on its rollers
by pulling the lever
located at the base
of the appliance hard
from right to left.
Once the appliance
is in the desired po-
sition, push the lever
back to its original
position. Accurate
levelling avoids vibrations, noise and pre-
vents the appliance from moving when run-
ning.
electrolux 45