Programmes Table - Electrolux WASL 3 T Benutzerinformation

40 electrolux
Time Manager
The cycle can be made longer or shorter by
using the "Time Manager"
The level of soiling of the laundry is also in-
dicated.
Soil level Icon
Intensive
Normal
Daily
Light
1)
Quick
1)
Super quick
1)
2)
Refresh
Super re-
2)
1)
fresh
1) To use on a half load.
2) The symbol flashes and disappears : this wash cycle
is a refresh cycle only.
The availability of these different levels var-
ies depending on the selected programme
type.
Start of the programme
Press the "Start/Pause"
start the cycle ; the corresponding light will
come on green and the symbol
pears on the display (door locked).
It is normal for the programme selector to
remain stationary during the cycle. The
symbol for the current cycle and the re-
maining time appear on the display. If a de-
layed start has been selected, the count-
down appears on the display.
Warming up
During the cycle, the
when the appliance is reaching the right
temperature.

PROGRAMMES TABLE

Programme / Type of washing
Cottons (cold - 90°) : White or colour,
e.g. normally soiled work clothes, bed linen,
table linen, body linen, towels.
pushbuttons.
Type of fabric
For heavy soiled
items
For normal soiled
items
For daily soiled items
For slightly soiled
items
For very slightly
soiled items
For items used or
worn for a short time
For refreshing items
only
For refreshing a very
few items only
pushbutton to
ap-
symbol comes on
Interrupting a programme
Adding washing during the first 10 mi-
nutes
Press the "Start/Pause"
the corresponding light will flash green while
the appliance is paused. The locking mech-
anism "snaps" twice to indicate that the lid
is open. The symbol
Press the "Start/Pause"
again to continue the programme.
Modifying the programme in progress
Before making any changes to the current
programme, you need to pause the wash-
ing machine by pressing the "Start/Pause"
pushbutton. If the modification is not
possible, "Err" flashes in the display and the
"Start/Pause"
a few seconds. If you still decide to change
the programme, you must cancel the cur-
rent programme (see below).
Cancelling the programme
If you want to cancel the programme, turn
the programme selector to the "Stop" posi-
tion .
End of the programme
The washing machine stops automatically ;
the "Start/Pause"
and "0" flashes on the display. The locking
mechanism "snaps" twice to indicate that
the lid is open. The symbol
pears. Turn the programme selector to the
"Stop" position. Remove washing. Un-
plug and close water inlet tap.
Stand by : once the programme has finish-
ed after a few minutes the energy saving
system will be enabled. The brightness of
the display is reduced. By pressing any but-
ton the appliance will come out of the ener-
gy saving status.
Load
6,0 kg Rinse hold, Night silence plus, Pre-
wash, Rinse plus, Time manager, De-
lay start
pushbutton :
disappears.
pushbutton
pushbutton flashes red for
pushbutton goes out
disap-
Possible options