Geberit ECO 203 Betriebsanleitung Seite 33

Cleaning and lubricating the Geberit pressing tool
WARNING
Fire risk from short circuit
Never clean the pressing tool with water or other liquids.
1
Disconnect the mains plug.
2
Clean the roller drive, its guide and the retaining pin of the pressing tool.
3
Use a brush to remove dirt.
CAUTION! Observe the safety notes of the lubricant used.
4
Use BRUNOX®Turbo-Spray® or equivalent to lubricate the roller drive, its
guide and the retaining pin as per figure C.
5
Wipe away excess lubricant using an absorbent cloth.
B1279-001 © 02-2016
966.996.00.0 (00)
EN
33