Maintenance - Makita BO6040 Bedienungsanleitung

workpiece surface. Keep the pad flush with the
workpiece and apply slight pressure on the tool.
Polishing operation
CAUTION:
Use only a Makita genuine sponge pad, felt pad or
•
wool pad (optional accessories).
Always operate the tool at low speed to prevent
•
work surfaces from damage/burning.
Never force the tool. Excessive pressure may
•
decrease the polishing efficiency and cause motor
overload, resulting in tool malfunction.
1. Applying wax
Fig.9
Use an optional sponge pad. Apply wax to the
sponge pad or work surface. Run the tool at low
speed to smooth out wax.
NOTE:
First, wax a not conspicuous portion of the work
•
surface to make sure that the tool will not scratch
the surface or result in uneven waxing.
2. Removing wax
Fig.10
Use an optional felt pad. Run the tool at low speed
to remove wax.
3. Polishing
Fig.11
Use an optional wool pad. Run the tool at low
speed and apply the wool pad gently to the work
surface.

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Never use gasoline, benzine, thinner, alcohol or the
•
like. Discoloration, deformation or cracks may
result.
To maintain product SAFETY and RELIABILITY, repairs,
carbon brush inspection and replacement, any other
maintenance or adjustment should be performed by
Makita Authorized Service Centers, always using Makita
replacement parts.
ACCESSORIES
CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
or attachments
Only use accessory or
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Hook-and-loop
•
pre-punched holes)
Hook-and-loop type sponge pad
•
Hook-and-loop type felt pad
•
Hook-and-loop type wool pad
•
Sanding cloth
•
Joint
•
Pad 150 (Super soft, Soft, Hard)
•
Side grip
•
Hex wrench
•
are
6
type abrasive discs (with