Axis Q8665–LE Installationsanleitung Seite 22

AXIS Q8665–LE PTZ Network Camera
• Turn the potentiometer clockwise to increase the threshold and advance the switch
to night mode.
• Turn the potentiometer counterclockwise to decrease the threshold and delay the switch
to night mode. Night mode is indicated by a red LED on the board. The switch to night
mode will activate the illuminators.
Install the Bracket (sold separately)
The brackets are sold separately. See www.axis.com for information on available mounting
accessories.
WARNING
Risk of injury. Make sure the product is secured to the building surface before operation.
Important
• When attaching the bracket to a concrete surface, use dowel pins with a traction torque
rating of ≤300 dN.
• When attaching the bracket to a metal surface, use screws with a diameter of 8 mm.
1. Prepare a wall, parapet or pole for installing the selected bracket.
2. Route the network and conduit cable through the bracket. Leave a cable slack of
50 cm (12 in) for connection to the base unit.
1
Network cable
2
Conduit cable with power and signal cables
1
2
4
22