Axis Q8665–LE Installationsanleitung Seite 21

N L
Incoming ma ins
4 5
1
Fuse holder and fuse (T8A L 250 V)
2
Fuse LED
3
Potentiometer P1
4
Mains supply block connector
5
Mains supply cable
6
Pan/tilt unit power supply cable (24 V AC) (pre-mounted)
7
Signal cable (pre-mounted)
3. Tighten the cable gland cap on firmly.
4. If needed, adjust the potentiometer P1 to increase or decrease the sensitivity of the
day/night sensor, see Adjust the Day/Night Sensor on page 21.
5. Close the light sensor box and tighten the screws.
Adjust the Day/Night Sensor
Note
The camera's built-in day/night sensor is activated per default. To use the day/night sensor
on the light sensor box it must be activated from the product's settings page.
If using the day/night sensor on the light sensor box, adjust the potentiometer to suit the specific
conditions on site.
AXIS Q8665–LE PTZ Network Camera
1
F1 F2
J2 J3
J1
L N
TR1 TR2 TR3
6
21
2
L 1 L 2 K 1
J4 J5
TR4 24~ 24~
status
- +
7
3
P1
J6