Principles Of Operation; Precautions For Use - miniland baby humitouch Bedienungsanleitung

ENGLISH

4.2. PRINCIPLES OF OPERATION

The humidifier uses the water stored in the water tank to make water vapour. The
machine's fan system releases this vapour into the dry air, creating the necessary
humidity.
5. INSTRUCTIONS FOR USE
5.1 INSTRUCTIONS FOR USE
1. Place the humidifier on a flat and horizontal surface in an appropriate location.
2. Remove the water tank (3) from the base of the unit (9), open the lid (4), fill the water
tank, close the lid, and place the water tank correctly on the base (Figure 2).
3. Plug the humidifier into the mains power supply and place the on/off switch (11) to
the on position 'I'.
4. Push the on/off button
illuminate with a blue light. Never power it on when the water tank is empty.
5. Push the button to adjust the vapour release
the desired flow of vapour among: low level, medium level, and high level.
6. Push the nightlight button
When the water tank is empty, the power status indicator will illuminate with a red light
and the humidifier will cease operating for reasons of safety.
NOTE:
• When it is cold, the windows and even the walls could fog up or allow frost to develop
due to excessive interior humidity. If this happens, reduce the vapour release
to avoid damage due to the condensation of the water.
• An excess of humidity in the room can cause the humidity to gather on the surfaces
where it could encourage the growth of bacteria and fungi. The accumulated humidity
could also damage the furniture and walls, especially wallpaper.
• In order to correct excessive humidity, especially in a small room, leave the door of
the room open and reduce the vapour release

5.2. PRECAUTIONS FOR USE

1. Do not fill the water tank (3) with water whose temperature is in excess of 40 °C to
avoid discolouring or deforming it.
2. Do not allow water to enter the interior of the body of the device by means of the air
outlet. Dry and water from the exterior part of the base with a dry cloth.
3. Do not insert metals, chemical substances, or detergents into the water tank,
because these actions could cause the release of vapour to be affected.
4. If the water tank is excessively full, do not move the device - the water could spill
over and come into contact with the interior of the body of the device, which could
cause damage to some internal components.
5. Never empty the water which remains in the hollow of the base without having first
turned off the device - the transducer would burn itself out immediately.
5.3. TROUBLESHOOTING
SYMPTOMS
The humidifier
does not work; it
releases neither
air nor vapour
(6) to power it on, the light indicator above the button will
(8) to switch the blue nightlight on or off.
CAUSE
It has not been connected
to the power supply
The humidifier has not
powered on
The water tank is empty
(7) several times in order to change
(7).
ACTION
Connect the humidifier to the mains
network
Power on the unit by pushing the
button
Fill the water tank
10
(7)