Principles Of Operation - miniland baby humitouch pure Bedienungsanleitung

ENGLISH
4.1. HUMIDIFIER (Figure 1)
1. Nozzle
2. Water tank
3. Water tank opening
4. Water filter
5. Lid of water tank
6. Control panel
7. Base of the unit
8. Ultrasonic transducer
4.1.2. CONTROL PANEL (Figure 2)
A. Level of vapour flow
B. Temperature
C. Timer hour
D. Relative humidity
E. Ozonator
F. Empty water tank
4.1.3 REMOTE CONTROL (Figure 3)
I. Power on/off
II. Adjustment of vapour release
III. Ozonator/nightlight
IV. Adjustment of relative humidity
V. Adjustment of timer

4.2. PRINCIPLES OF OPERATION

The humidifier uses the water stored in the water tank to make water vapour. The
machine's fan system releases this vapour into the dry air, creating the necessary
humidity.
5. INSTRUCTIONS FOR USE
5.1. ADDING WATER (Figure 5)
It is recommended that user use distilled water for the first time the humidifier is
powered on. (Follow the instructions detailed in the Cleaning section).
To add water, follow the instructions below:
1. Place the device on a flat surface. Remove the water tank (2) from the base of the
unit.
2. Hold the water tank (2) in an inverted position (upside down). Remove the lid from
the water tank (5), twisting it anti-clockwise.
3. Add cold water to the water tank. Do not add hot water, this could cause leakage.
4. Put the lid back on the water tank carefully and check that it is well fastened and that
there are no leaks.
5. Hold the water tank in a vertical position and place it back in the base. Place the
nozzle in the hole in the surface of the water tank.
NB:
1. Use the handle to move the full water tank, supporting it from below at the same time
with your free hand.
2. Do not add water directly to the base, this could damage the device or bring about
a dangerous situation.
3. Do not move the device when the water tank is totally full.
5.2. POWERING THE HUMIDIFIER ON AND OFF
Plug the humidifier into the mains power supply and push the power on/off button
9. Air outlet
10. Essence compartment
11. Mains adaptor
12. Temperature and humidity sensor
13. Nightlight
14. Remote control
15. Additional sponges
G. Adjustment of relative humidity
H. Power on/off
I. Adjustment of vapour release
J. Ozonator/nightlight
K. Adjustment of relative humidity
L. Adjustment of timer
14