Transport And Storage - Husqvarna K970 IIl Chain Bedienungsanweisung

Proper sequence cutting a pipe
1 First cut section I.
2 Move to side II and cut from section I to bottom of the
pipe.
3 Move to side III and cut the remaining part of the pipe
ending at the bottom.
I
III
How to aviod kickback
Avoiding kickback is simple.
• The work piece must always be supported so that the
cut stays open when cutting through. When the cut
opens there is no kickback. If the cut closes and
pinches the cutting equipment there is always a risk of
kickback.
• Take care when inserting the chain in an existing cut.
Never cut in a narrower pre-cut cut.
• Be alert to movement of the work piece or anything
else that can occur, which could cause the cut to close
and pinch the cutting equipment.

Transport and storage

• Secure the equipment during transportation in order
to avoid transport damage and accidents.
• For transport and storage of diamond chains, see the
section "Diamond chains".
• For transport and storage of fuel, see the section
"Fuel handling".
• Store the equipment in a lockable area so that it is out
of reach of children and unauthorized persons.
18 – English
OPERATING
II