Electrolux EFA9620 Bedienungsanleitung Seite 13

Touch Basic functions
control
Dual Function
L
When briefly pressed it switches the lighting
system on and off.
When pressed for 2 seconds it starts the
lighting system in "courtesy light" mode.
The lamps are fed at a reduced power of
approximately 5W. Such function can be
stopped by pressing the touch control for 2
seconds or just by pressing it shortly in order to
return to the normal lighting mode. In courtesy
light mode the touch control is not lit.
T1
When pressed the motor is stopped, regardless
of the speed it is set to.
T2
When pressed the motor is set to the first speed
T3
By a brief pressing the motor is set to the second
speed.
By pressing the touch control for approximately
2 seconds the Delay function is enabled, i.e
delayed shutdown of the appliance ensuring
a complete elimination of the residual odours.
This function can be activated at OFF-position
and at 1°, 2° and 3°speeds. It can be stopped
in advance by pressing any of the touch
controls (T) with the exception of T3. The Delay
function works according to the following
scheme:
1°speed / OFF
2°speed
3°speed
T4
When pressed the motor is set to the third speed
T5
When pressed the motor is set to the intensive
speed timed to 5 minutes. At the end of 5
minutes of intensive speed the hood starts again
at the speed it was set to previously. In case the
hood is set to the intensive speed directly from
OFF-state it will then start from the first speed
after 5 minutes of intensive speed.
F
When pressed for 4 seconds it resets the filter
alarm signal indicated by flashing of the touch
control T1. This procedure can be carried out
only when the motor is stopped.
= 20 minuets
= 15 minutes
= 5 minutes
Indicator lights
Touch control Lights off
unlit
Touch control lit Lights on
Touch control Courtesy light on
unlit
Touch control lit Motor on
Touch control Motor off
unlit
Touch control lit
Touch control lit Second speed on
Flashing touch Delay function on
control
Touch control lit
Touch control lit
Touch control lit Metal grease filters saturation
alarm. Metal grease filters need
to be washed. The alarm starts
up after 100 working hours.
Flashing touch Charcoal filter saturation
control alarm. Charcoal filter has to
be replaced and metal grease
filters washed. The alarm
starts up after 200 working
hours. (Activation; check the
paragraph "Charcoal
electrolux 13
Use
filter")
EN