Termozeta La Continua TZ2 STIRONOSTOP Gebrauchsanweisung Seite 19

boiler base (2) become very hot. Do not touch them in order to avoid
burns.
- On first use and whenever the appliance is enabled, when you
first press the steam button (15) on the iron, a vibration noise
will be heard: this is perfectly normal due to the internal pump.
This noise will disappear after few seconds.
IRONING
• Before ironing delicate fabrics it is best to make trial run on a
hidden piece e.g. the hem.
• We advise you to iron more delicate fabrics needing low
temperatures first, then go on ironing more resistant fabrics
needing higher temperatures.
• Press button (15) on the iron for the steam jet: the steam will
gradually stop coming out when you release the button.
• Rest the iron on the boiler base (2) during ironing pauses.
WARNING!
Some drops of water may leak out of the iron soleplate (16) when the
first jet of steam starts coming out; this is quite normal and is due to
condensation forming inside the iron-boiler connecting tube (8).
This will disappear with the following jets of steam. It is therefore not
recommended to point the first jet of steam directly on the item to be
ironed. The iron must be used and left at rest on a firm surface.
STEAM QUANTITY ADJUSTMENT
• Everytime the appliance is switched on,
the steam level is set to the maximum
value.
• To adjust the steam quantity emitted by the iron during the ironing
process, press the push button (6):
ONCE for MEDIUM steam
ŸŸŸ
ENGLISH