Hama 99106994 Bedienungsanleitung Seite 10

• Press "MODE" to confirm your setting.
• The hour display starts to flash. Now use "UP" and "DOWN" to set the correct hour.
• Press "MODE" to confirm your setting.
• The minute display starts to flash. Now use "UP" and "DOWN" to set the correct minute.
• Press "MODE" to confirm your setting and end the setting procedure.
Alarm setting
• Press "MODE" to see alarm time.
• Press "UP" to activate or deactivate the alarm. If you activate the alarm function, the alarm
symbol will display on the screen.
• Press and hold the "MODE" button for two seconds.
• The hour display starts to flash. Now use "UP" and "DOWN" to set the request hour.
• Press "MODE" to confirm your setting.
• The minute display starts to flash. Now use "UP" and "DOWN" to set the request minute.
• Press "MODE" to confirm your setting.
• The Snooze Time start to flash, now use "UP" and "DOWN" to set the request Snooze time.
• Press "MODE" to confirm your setting. The screen automatically switches to home time
version.
Automatic snooze function
• Proceed as follows to activate the automatic snooze function:
while the alarm is sounding, press the "SNZ" button to activate the snooze function.
When the snooze function is active, the "Zz" symbol appears in the display.
• This operation moves the alarm back by the Snooze Time and the alarm will restart at this time.
• The snooze function can be interrupted by pressing any other buttons or the alarm is over.
°C/°F temperature display
The temperature is displayed either in °C/°F. Briefly pressing the "DOWN" button to switch °C/°F
display.
Max./Min. Temperature/Relative Humidity
• To toggle indoor/outdoor max./min. temperature & humidity data, press the "MX/MIN" button:
Once to show the maximum temperature and humidity values.
Twice to show the minimum temperature and humidity values.
Three times to return to the current temperature and humidity levels
• To reset the maximum and minimum temperature and humidity, press and hold the "MAX/
MIN" button 2 seconds. this will reset all minimum and maximum data recorded to the current
displayed values.
Radio connection to outdoor sensor:
• Use a screwdriver to open the transmitter compartment lid on unit back
• Insert 2x 1,5V AAA batteries. Pay attention to observe the correct polarity. Replace the battery
compartment lid and 4 screws.
20
• Transmitter detects the actual environment temperature and transmits this information to the
receiver (weather station) through radio waves, the LED light flashing for show to show that
the unit is transmitting.
• At the same time, the weather station will start to receive signals on the screen in the outdoor
temperature display.
• Press the "UP" button to select a channel (1 to 3). this gives you the option of polling 3 outdoor
sensors with the weather station.
• Press and hold down the "UP" button for 2 seconds to search for outdoor sensors.
Weather forecast
The weather is based on the temperature and humidity changes to create the next 12-hour
weather forecasts the stations uses 4 icons: sunny, slightly cloudy, cloudy, rainy
sunny slightly cloudy
Projection Clock & Backlight:
Briefly press the „SNOOZE/LIGHT" button to activated the display lighting for 5 secinds, also the
displayed time will be projected on the wall at the same time.
If you are using a DC Power adaptor, the display lighting & projection clock will stay illuminated
permanently.
Warning
Do not dispose of exhausted batteries by throwing them into a fire. this may cause an explosion
or serious injury.
cloudy rainy
21