Husqvarna TS 400 F Betriebs- Und Wartungsanleitung Seite 32

12 Adjustments
• The machine is set before leaving the factory
and no adjustment is necessary.
• However, after shocks, loosening of nuts and
bolts, or sharp movements when tilting the head,
if necessary adjust the stop screws(D) and
check the squareness (for straight cuts) .
• To correct the bevel cutting setting, adjust the
stop screw (E) and lock the nut with a lock- nut
(SEE FIG. 18).
• Ø 300 or Ø 350 or Ø 400 adaptation (SEE FIG. 19)
Act on the depth's adjustement to choose the
position corresponding to the blade.
13 Important advice
• Retighten the nuts and bolts periodically.
• In the event of a long period of use pay special
attention to the maintenance and protection of
the disc.
• Make sure that sufficient water is sprayed onto
the disc.
• Tighten the disc correctly.
• Make sure that the contact faces of the disc, the
flanges and the spindle are clean.
The manufacturer declines all respon-
sibility for loss or damage resulting
!
from misuse or any modification, alte-
ration or powering that does not
conform to the manufacturer's original
specifications.
At the work station, the sound pres-
sure level may exceed 85 db (A)
In this case individual protection
measures must be taken.
24
14 Repairs
Contact your supplier who is entirely at
S
your service to carry out repairs in the
A
shortest time at the best possible price.
V
15 Spare parts
For rapid delivery of spares and in order to avoid
any wasted time, it is necessary to remind your
supplier of the details shown on the instruction
plate on the machine with each order, as well as
the reference of the part to be replaced.
00000000
Item numberCode
See exploded view
16 Scrapping
In the event of deterioration and
scrapping of the machine, the follo-
!
wing items must be disposed of in
accordance with the requirements of
the legislation in force.
• Main materials :
Motor : Aluminium (AL), Steel (AC),
Motor : Copper (CU), Polyamide (PA)
Machine : Steel sheet (AC), Cast iron (FT)
The instructions for use and spare parts found in this
document are for information only and are not binding.
As part of our product quality improvement policy, we
reserve the right to make any and all technical modifi-
cations without prior notice.
(0)
Quantity