Panasonic ER-SC40 Bedienungsanleitung Seite 17

Lubrication
• Apply the oil to the blade before and after each use.
1
Remove the blade.
(See this page.)
2
Apply a drop of the oil to each
indicated point.
3
Attach the blade to the main
body, turn on the power and
allow to run for
approximately 5 seconds.
► Replacement part
Replacement part is available at your dealer or Service Centre.
Replacement part for ER‑SC60/
ER‑SC40
ER-SC60_40_EU.indb 17
Blade WER9521
Removing and mounting the blade
► Removing the blade
Hold the main body with the switch
facing upward and push the blade with
your thumb while catching the blade in
your other hand.
► Mounting the blade
Fit the mounting hook (B) into the blade mounting (A) on the
main body and then push in until you hear a click.


17
2017/05/25 9:13:21