Warranty Terms - Concept LO 7045 Bedienungsanleitung

WARRANTY TERMS

EN
Warranty
The manufacturer (or importer) is responsible for en-
suring the product complies with the requirements of
applicable legal regulations as well as those of the rel-
evant technical standards. Moreover, they are respon-
sible for ensuring the product has the properties the
manufacturer described in documents related to the
goods or those reasonably expected by the customer
with regard to the nature of the goods or based on
advertising produced by the manufacturer, and fur-
ther they are responsible for ensuring the product is
t for the purpose proposed by the manufacturer or
that a product of the same type is normally used for.
The quality warranty term is 24 months from product
takeover by the customer.
The warranty does not apply to wear and tear caused
by regular use. The customer shall not be entitled to
any warranty claims if, prior to taking the product
over, they knew the product contained a defect or if
the defect is attributable to the customer.
The warranty speci cally does not apply:
• if the product installation, operation and service
conditions stipulated in the product operating
manual have not been adhered to,
• to malfunctions caused due to mechanical, heat
or chemical damage, short circuit, over voltage or
incorrect installation,
• to malfunctions caused by an inexpert third-party
intervention,
• to malfunctions caused by natural disaster,
• to malfunctions caused by insu cient or inappro-
priate maintenance in violation of the operating
manual, including malfunctions caused by water
and other sediments,
• to changes in colour of the heating surface or to
scratching of the surface caused as a result of us-
ing the products in an unusual manner,
• to appearance and functional changes caused by
exposure to sunlight, thermal radiation of water
and other sediments,
• if the service life of certain product parts expires,
e.g. for accumulators, bulbs, etc.
66
The warranty does not apply to any products and ser-
vices provided along with the product (gifts, promo-
tional articles, etc.).
Filing a complaint
A complaint against a product defect must be led as
soon as identi ed, yet no later than before the end of
the warranty term.
The customer must le a product complaint with
the dealer from which they have purchased the pro-
duct, or with any authorised service centre, a list of
which is included in the product package, or available at
www.my-concept.com.
While ling a product complaint, the product must
be duly cleaned and securely packed so as to prevent
any damage during its transport to an authorised
service centre, where relevant, unless the product is
delivered in person.
The customer must submit proof of having conclud-
ed a purchase contract for the product by producing
the receipt.
While ling their complaint, the customer must indi-
cate the noted defect and identify the preferred com-
plaint application method.
Complaints processing
As long as the noted defect may be removed, the user
has the right to have the defect duly removed free of
charge on a timely basis.
Where such a procedure is not reasonable with re-
gard to the nature of the defect, the user may require
to be supplied a new defect-free product (replace-
ment), or, where the defect applies to a part of the
product only, replacement of the part concerned.
However, if replacement of the product or any part
thereof is not proportionate with regard to the nature
of the defect, especially if the defect can be removed
without undue delay, the customer has the right to
have the defect removed free of charge.
LO 7045 | LO 7046