Install The Hardware - Axis Q6042-E Installationsanleitung

Connectors
SD Card Slot
Supports SD cards with up to 64 GB of storage. For best recording performance, use an SDHC
or SDXC card with speed class 10.

Install the Hardware

NO TICE NO NO TICE TICE
• The product shall be connected using a shielded network cable (STP). All cables connecting
the product to the network shall be intended for their specific use. Make sure that the
network devices are installed in accordance with the manufacturer's instructions. For
information about regulatory requirements, see Electromagnetic Compatibility (EMC)
on page 2.
• Mount the product with the dome cover facing downward.
• Be careful not to scratch, damage or leave fingerprints on the dome cover because this
could decrease image quality. If possible, keep the protective plastic on the dome cover
until the installation is complete.
The Axis product can be installed with the cables routed through or along the wall or roof.
Read all the instructions before installing the product. Some installation steps would benefit from
being completed together because they require removal of the dome cover.
A hardware installation can include the following:
• The product is supplied with a clear dome cover (premounted). A smoked dome cover is
available as an accessory. To replace the dome cover, see page 16.
• A standard or high capacity SD card (not included) can be used to store recordings locally
in the product. To install an SD card, see page 16.
• To install the product using a compatible bracket from AXIS T91A Mounting Accessories
(sold separately), see page 16.
• To install the supplied midspan, see page 18.
Attach the Sunshield
Attaching the sunshield is optional. The sunshield protects the camera against UV light and helps
keep the temperature inside the camera down.
1. Slide the sunshield over the unit holders on the camera unit.
2. Secure the sunshield using the supplied screws (T20).
AXIS Q60 Series
15