Connectors And Buttons - Axis Q6042-E Installationsanleitung

Green, flashing
AC Green

Connectors and Buttons

For specifications and operating conditions, see page 14.
Network Connector
RJ45 Push-pull Connector (IP66) with High Power over Ethernet (High PoE).
NO TICE TICE
NO NO TICE
Use the supplied midspan.
NO TICE NO NO TICE TICE
The product shall be connected using a shielded network cable (STP). All cables connecting
the product to the network shall be intended for their specific use. Make sure that the
network devices are installed in accordance with the manufacturer's instructions. For
information about regulatory requirements, see Electromagnetic Compatibility (EMC) on
page 2.
NO NO TICE NO TICE TICE
To comply with the IP66-rated design of the camera and maintain the IP66 protection,
the supplied RJ45 Push-pull Connector (IP66) shall be used. Alternatively, use the RJ45
IP66-rated cable with premounted connector which is available from your Axis reseller. Do
not remove the plastic network connector shield from the camera.
SD Card Slot
An SD card (not included) can be used for local recording with removable storage. For more
information, see Specifications on page 14.
NO TICE NO NO TICE TICE
To prevent corruption of recordings, the SD card should be unmounted before removal. To
unmount, go to Setup > System Options > Storage > SD Card and click Unmount.
Note
For SD card recommendations see www.axis.com
Fast flash when input voltage is out of range or other
internal error.
Steady when AC power input connected.
13
AXIS Q60 Series