Led Indicators; Connectors And Buttons - Axis V5915 Installationshandbuch

LED Indicators

Status LED
Unlit
Green
Amber
Amber/Red
Red
Microphone power LED
Unlit
Blue
Note
The tally LED can be configured to be lit or unlit during normal operation. To configure,
go to Setup > System Options > Ports & Devices > LED. See the online help for more
information.
Tally LED
Unlit
Red

Connectors and Buttons

For specifications and operating conditions, see page 11.
BNC Connector
The BNC connector is used for connecting broadcast equipment using SDI. Connect a 75 Ohm
coaxial SDI cable.
CAUTION
The connector may be hot during normal operation in elevated ambient temperatures.
Indication
Connection and normal operation.
Shows steady green for 10 seconds for normal operation after
startup completed.
Steady during startup. Flashes during firmware upgrade.
Flashes amber/red if network connection is unavailable or lost.
Flashes red for firmware upgrade failure.
Indication
Phantom power off.
Phantom power on.
Indication
Camera idle.
Active transmission or recording.
9
AXIS V59 Series