Maintenance; General; Maintenance Schedule; General Inspection - Husqvarna LC 348V Bedienungsanweisung

General

WARNING! The user must only carry out the
!
maintenance and service work described in
this Operator's Manual. More extensive work
must be carried out by an authorized service
workshop.
Prevent unintentional starting by removing
the ignition cable from the spark plug.
The life span of the machine can be reduced
and the risk of accidents can increase if
machine maintenance is not carried out
correctly and if service and/or repairs are
not carried out professionally. If you need
further information please contact your
nearest service workshop.
• Let your Husqvarna dealer regularly check the machine
and make essential adjustments and repairs.
• Always use genuine accessories.

Maintenance schedule

In the maintenance schedule you can see which parts of your
machine that require maintenance, and with which intervals it
should take place. The intervals are calculated based on daily
use of the machine, and may differ depending on the rate of
usage.
Daily Weekly

maintenance

maintenance
General
Spark plug
inspection

Oil level

Muffler*
Vibration
External
damping
cleaning
system*
Cutting
equipment
Cutting cover
and protective
cover*
Engine brake
handle*
*See instructions in the section "Machine's safety
equipment".

General inspection

• Check that nuts and screws are tight.
LC353VB
Make sure the cable clip is properly secured to the bracket. If
the cable clip feels loose or have fallen of, mount the clip back
into place.
MAINTENANCE
At least once
50 hours
a year
Replacing and Replacing and
adjusting the V- adjusting the
belt V-belt
Air filter Air filter
Fuel system Fuel system

Oil change

Oil change

External cleaning

• Brush leaves, grass and the like off of the lawn mower.
• Do not use a high pressure washer to clean the machine.
• Never flush water directly on the engine.
• Clean the air intake on the starter. Check the starter and
starter cord.
• When cleaning under the cutting deck, turn the machine
with the spark plug upwards. Empty the fuel tank.
Cleaning of the gear housing.
• Remove the service hatch.
• Brush leaves and grass off of gear housing. If necessary
clean the gear housing with water. For LC348Ve and
LC353VE make sure the battery is disengaged.
Oil level
The lawn mower should stand on flat ground when you check
the oil level. Check the oil level with the dipstick on the oil filler
cap.
• Remove the oil cap and wipe the dipstick clean.
• Put the dipstick back in. The oil filler cap must be
completely screwed down to give a correct picture of the
oil level.
• If the oil level is low, fill using engine oil up to the upper
level on the dipstick.
Oil change
• Empty the fuel tank.
• Unscrew the oil filler cap.
• Place a suitable vessel to collect the oil in.
• Drain the oil by tipping the engine so that the oil runs out
through the filler pipe. Ask where you can dispose of
surplus engine oil at your local petrol station.
• Fill with new engine oil of a good quality. See instructions
in the section "Technical data".

Cutting equipment

WARNING! Always wear heavy-duty gloves
!
when servicing and maintaining the cutting
equipment. The cutters are very sharp and
cuts can occur very easily.
• Damaged blades should be replaced when hitting
obstacles that result in a breakdown.
• Replacement or sharpening of the blades must be carried
out by an authorised service workshop.
– 77
English